ACTi ACM-3300 Manual de usuario descargar pdf (Pagina 51)

*Pre-requisites: SMTP server / HTTP CGI server setup.

low when the event ends. Interval determines the minimum duration of

each DO response( in seconds). DO will remain at the active level during this

time, and if another event triggers DO before the end of the first DO, the

second trigger will no take effect. 0 means there is no minimum duration.

Notification messages:

Notification messages may be sent to either an email or a HTTP CGI

server. If sent to an CGI server, it works the same as an URL command, but

it does not allow a second message at end of event. You may configure up to

three preset massages. You can configure a message, but disable it. This will

allow you to keep the settings without using it, which will be useful in testing

and troubleshooting.

To setup Notification Messages, make sure to enable the message,

then determine what type of message to send (HTTP CGI or email).

If you are sending to CGI server, you need to enter the CGI path ,

the URL command itself , and an optional message .

If you are sending email , please enter the receipient address , the

email subject , and the body message . Click [Apply] to use these

settings or click [Reset] to clear changes.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 68 69

Sin comentarios

ACTi ACM-3300 Manual de usuario Pagina 51