ACTi ACM-3300 Manual de usuario descargar pdf (Pagina 36)

■Camera setting

Parameters

Description

Video Mirror

Check this box to mirror the video left-right

BLC

Check this box to enable back light compensation

White Balance

Mode

Select the white balance mode. After you set the

parameter, you need to wait for 5~10seconds to see the

final result.

1. AUTO : Auto white balance (default)

2. INDOOR1: Select the indoor white balance profile 1.

3. INDOOR2: Select the indoor white balance profile 2.

4. OUTDOOR1: Select the outdoor white balance

profile 1.

5. OUTDOOR2: Select the outdoor white balance

profile 2

6. HOLD CURRENT: Select this to let the IP camera

automatically obtain a best white balance setting

according to current environment. The IP camera will use

this setting to adjust color.

NOTE: This setting will be lost after you

reboot the camera.

7. MANUAL: Select this to enable manual setting of the

white balance. You will need to enter the R Gain and B

gain setting below.

Exposure mode

Select the Exposure Gain of the IP camera. The higher

the value = brighter images.

AGC Gain

(In auto Exposure

mode only)

When exposure mode is auto, IP camera will adjust its

shutter speed according to AGC gain and the Maximum

auto shutter speed. Higher AGC gain = brighter images.

IRIS DC Level

Control in detail the level of DC Iris opening strength here.

If you do not know what this value is for, please don’t’ use.

Shutter Speed

Increase or decrease the shutter speed. The higher the

value, the better the nighttime performance. Although

higher values also causes motion to become blurry.

Line Frequency

Change settings between 60Hz or 50Hz, depending on

the AC power type of your region

Detection Source

Select the method used by Camera to determine

illumination level. It can be either CDS light sensor or

through image analysis by DSP. Not every model will

allow selection for this.

An additional Day / Night control selction will appear when

the source is set as DSP. You may choose AUTO to

change between day and night by threshold value, or

choose either DAY or NIGHT to stay in that mode no

matter the light.

Day to Night

Threshold

This value controls the level of light where camera

switches into night mode. Increasing it will make camera

switch to night mode at a darker illumination level.

Day to Night

Timer

The camera will only switch day/night status if the

illumination level stays either above or below the boundary

for this much time. This is to prevent a temporary

brightness change from triggering unnecessary day/night

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 68 69

Comentarios a estos manuales

Sin comentarios

ACTi ACM-3300 Manual de usuario Pagina 36

Comentarios a estos manuales

Relacionado con productos y manuales para Cámaras De Seguridad ACTi ACM-3300