ACTi E66 Guía de instalación descargar pdf (Pagina 16)

E-16



Removal/Attachment the Rear Cover

• Use a screwdriver to loosen or tighten the screws. Be sure not to

tighten screws too tightly, since it may damage the unit.

• Be careful when removing or inserting any screws that they do not

fall inside the PS-A.

Unscrew the eight (8) attachment screws used to hold the Rear Cover in place, and

remove the Rear Cover.



Installation Requirements

• To enhance the PS-A's maintainability, operability and ventilation, allow at least

100 mm clearance between the PS-A and other objects. (The clearance must be

large enough to allow you to install or uninstall option units and to attach con-

nectors.)

• Standard installation for the PS-A unit is in a vertical panel. If the PS-A unit is

to be installed in a slanted panel, the panel should not incline more than 30°

from the vertical.

• Horizontal installation (that is, rotating the panel so that one of its sides is the

base) is not supported.

(unit: mm[in.])

100

[3.94]

100

[3.94]

100

[3.94]

100

[3.94]

100

[3.94]

100 [3.94]

1 2 ... 11 12 13 14 15 16 17 18 19 20

Sin comentarios

ACTi E66 Guía de instalación Pagina 16