
Firmware User’s Manual V5.12.12
13
Click the icon to enable the audio out from PC to IP
camera or video server. When it is enabled, your voice will be
transferred to the audio out of the IP camera or video server.
NOTE: you will need to have a microphone connected to your PC
to send out audio.
If dual stream mode is enabled, click to select which stream to
display (Media 1 or 2). The default is single stream only. To change
to dual stream mode, please refer to “Media 1” section under
“Setup” tab
Click to select the compression codec used in video encoding.
The Encoder type option includes MPEG-4, MJPEG and H.264.
Once selected, the video server/IP camera will start to send video
in new stream type.
Click or to adjust display screen size
Click the speaker icon to toggle mute / audio in. Click and drag to
decide volume below. You must first enable audio in setting to
change here.
Click on the PTZ button to pop up the Control panel, and enable
Mouse PTZ at the same time. For zoom lens camera, Panning and
Tilting via PT platform will only be activated by mouse PT
command.
*Note: This is not available in 4 cropped VGA mode.
Click to set DO output level to High. Click to set DO
output level to Low. If your device has more than one DO available,
each DO is controlled separately.
Indicates the network state. If the light on the right is green,
it means the network is ok. If the light is gray, it means the network
is broken. The light on the left is not used
Live view from Camera is displayed here. The title bar shows the
time and date.
If you want to setup this IP camera/video server, please click the [Setup] tab to switch to
“Setup Page”
Comentarios a estos manuales